Skip to main content

Products

Natural gas furnace

Powerful, immediate heat, even at −30 °C. Current models reach 99% efficiency and modulate their output instead of running all-or-nothing.

Heat, right now

A natural gas furnace burns fuel to heat an exchanger, and the blower pushes that warm air into your ducts. It is direct, fast and powerful: at −30 °C, a gas furnace does not falter.

That is its genuine advantage, and in Quebec it counts.

What has changed since your last furnace

If you are replacing something installed in the 1990s or 2000s, three things are different:

Efficiency. Today’s condensing models run from 93% to 99% AFUE. The units they replace were often between 65% and 80%.

Modulation. A modern furnace is no longer a switch. Two-stage models spend most of the winter on low fire, and a modulating model adjusts its flame continuously. The result is smaller temperature swings, less start-up noise, and a blower that keeps air moving steadily instead of blasting in bursts.

Venting. A condensing furnace no longer vents up the chimney but through a PVC pipe out the wall, and it produces condensate that has to drain. That affects where the unit can go, and it is part of what we check on site.

Our relationship with Énergir

We have been a certified Énergir partner — formerly Gaz Métro — since the 1970s. We work with their network, requirements and timelines routinely.

We also pair gas furnaces with an electric heat pump in a dual-energy system, where the heat pump carries most of the season and the furnace takes over in deep cold. If you are replacing a furnace anyway, it is worth pricing both.

See how dual energy works.

At a glance

Efficiency (AFUE)
93% to 99% depending on model
Firing stages
single-stage, two-stage or continuous modulation
Blower
variable-speed ECM motor across the current range
Typical service life
18 to 25 years with annual maintenance
Maintenance
annual, including mandatory carbon monoxide checks

The Lennox lines

Series Signature

The top of the range: a modulating burner that adjusts output in fine increments rather than firing flat out, reaching up to 99% efficiency. The most comfortable and quietest furnace we install.

Series Elite

Two-stage, 96–97% efficient, with a variable-speed blower. The common choice for a replacement in a West Island home.

Series Merit

96% efficiency, in two-stage or single-stage form. The entry point, with the same ECM blower motor.

Model line-ups change from year to year. We confirm what is available at the time of your quote.

Frequently asked questions

What does AFUE mean?

AFUE is the percentage of the gas you burn that actually becomes heat in your house. A 96% furnace turns 96 cents of every gas dollar into heat and loses the other four up the flue. A furnace from the 1980s often sits between 65% and 78% — the replacement alone changes the bill.

Single-stage, two-stage or modulating — what is the difference?

A single-stage burner is either full-on or off. Two-stage adds a reduced setting, which it uses most of the time. A modulating burner adjusts continuously. The finer the modulation, the steadier the temperature from room to room and the less noise you hear at start-up.

Should I switch to electric instead?

It is a fair question, and the answer depends on your home. Converting to a central heat pump unlocks substantial rebates and takes you off the gas bill, but it assumes an electrical panel that can support it. If your gas furnace is under ten years old and running well, replacing it now rarely makes sense. We price both scenarios during the evaluation.

Do I need a carbon monoxide detector?

Yes, and it is not negotiable. Any combustion appliance needs a working CO detector on every occupied floor. Our technicians verify combustion and venting at every maintenance visit.

Our credentials

Lennox Premier DealerRégie du bâtiment du QuébecCorporation des maîtres mécaniciens en tuyauterie du QuébecCommission de la construction du QuébecCertified Énergir partner

In business since 1955 RBQ licence 1136-3629-82

Let’s talk about your project

One of our advisors comes to your home, measures what needs measuring and walks you through your options — free, and with no pressure.

Monday to Friday · 8:30 a.m.–12 p.m. and 1 p.m.–5 p.m. Emergency service is available during the winter months to customers holding a maintenance contract.